The S2 has the same inlet diameter as stock (2.25”). Only things you will need to modify is relocation of the boost control solinoid. It’s a direct bolt in capable of 40 lbs/min of air flow. The benefit with the S2 over the S1 is added response and mid range from the larger A/R ratio of the compressor housing and an upgraded wastegate actuator. Peak power stays the same. This is what you get when you order an S2!
- GT28 Turbine wheel
- BNR’s custom GT2860 compressor wheel (40 lbs/min flow rate)
- High Performance 360 thrust assembly
- Wide journal bearings
- Rear journal bearing oil deflector (Diverts oil away from the turbine seal)
- High Performance turbine seal
- Balanced and blue printed to .5 gram/in2
- BNR’s custom T2 bearing housing (uses all OE oil and water fittings)
- BNR compressor housing
- BNR .63 a/r turbine housing with 27mm wastegate port
- Upgraded wastegate actuator (set at 13 psi)
- All stainless hardware
- 5 Layer stainless MLS turbine inlet/outlet gaskets
- (9) M10 1.5 exhaust studs
- Extended stainless water line (firewall side)
- (4) 14mm copper sealing rings
- 1 year warranty!
No core required!